Tiptronic warning lamp comes on transmission is in emergency mode

Detectable faults: Open circuit/short to gound, short to positive

1) Check operation with Tester 9288 (drive link test)

- Acoustical test

Triggering cycle of valves is audible as a clicking noise near the transmission.

2) Pull connector off Tiptronic control unit.

a) Measure resistance between pin 42 and pin 19. Nominal value 34 Ohms, tolerance 10 %

b) Check that pins 42 and 19 are free from shorts to ground.

3) Also pull off connector at transmission.

- Check wiring (Tiptronic control unit connector pin 42 to transmission connector pin L and Tiptronic control unit connector pin 19 to transmission connector pin M).

- Wiring o.k.: Solenoid valve faulty Figs. 1, 8

Test point 17

Solenoid valve 4

Fault code 40

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment