Adjusting drive pinion

The setting dimension "E" is indicated on the

1. Install drive pinion without shims "S3" and tighten all pan head screws of bearing assembly to 50 Nm (37 ftlb).

2. Rotate adjustable stop ring along with spindle towards measuring plunger as far as it will go and set second setting ring to dimension"a".

J

QU 1 c?>

1 OTra

969-38

3. Assemble measuring mandrel and set with master gauge VW 385/30 to setting dimension "E" (64.05 mm in the example). Set dial gauge (3 mm measuring range) to zero with 1 mm preload.

4. Put gauge block plate 9281 on drive pinion head and insert measuring mandrel with dial gauge towards transmission side cover into transmission case. Dial gauge extension points towards center of drive pinion.

Porsche Classic Models

Porsche Classic Models

The History of Porsche Cars through its generational changes. A must have ebook for any Porsche fanatic, this ebook is a reference book for Porsche enthusiasts. Discover all there is to know about the greatest Porsches ever made. All models are fully described and illustrated providing a definitive production history plus an accurate guide to original specs and equipment.

Get My Free Ebook


Post a comment