Dismantling and assembling input shaft Tools

How Make Simple Hho Dry Cell

No.

Designation

Special tool

Order number

Explanation

1

Insert

9282

000.721.928.20

2

Socket

9105

000.721.910.50

35 40 37 Dismantling and assembling input shaft

Input Shaft Bearing Race Carrera

Four-point bearing Tensioning plate

Bearing inner race

Thrust washer Loose gearwheel (4th Synchronizing ring

Where The Shift Fork Shaft Gear

Four-point bearing Tensioning plate

Press off with suitable separating device (e.g. Kuk-ko 17-1)

Mark for reinstallation

Clamp in a vise (use pro tective jaws), insert lock (long), engage 5th gear and install input shaft with pinned shift rod/shift fork

Large, face-ground side faces needle cage

Replace only in pairs

Check for wear, install in correct position using the same gearwheel (lugs face the driver dogs)

Press off with suitable separating device (e.g. Kuk-ko 17-1)

Mark for reinstallation

Large, face-ground side faces needle cage

Replace only in pairs

Check for wear, install in correct position using the same gearwheel (lugs face the driver dogs)

No.

Designation

Removal

Installation

10

Needle-roller assembly

1

Mark cage

install with the same gear-wheel

11

Inner race

i

Heat to approx. 120 °C

12

Guide sleeve

1

Remove complete with shift sleeve

Install compiele wiih shaft sleev/e and synchro-mesh components

13

Shift sleeve (3rd and 4th gear)

1

Make sure synch romesh components do not pop out.

Observe installation posi-fion, inslaii complete wflh guide sleeve and synchro-mesh components. Center the centerpunch marks relative to the driver dogs

14

Driver dogs

3

lns:aii in correct position, domed side faces shifi sleeve

15

Ball

3

16

Spring

3

17

Synchronizing ring

1

Mark for reinstallation

Check for wear, install in correct position with the same gearwheel (lugs face ihe driver dogs}

18

Loose gearwheel (3rd gear}

1

Replace only in pairs

19

Needle-roller assembly*

1

Mark for reinstallation

Fit with the same gearwheel

20

Inner race*

1

Heat to appro*. 120 °C and press into place

21

Thrust washer (1.85 mm thick}*

1

22

Fixed gearwheel (2nd gear)"

1

Press off with suitable separating device (e.g, Kukko 17-0)

Replace onty in pairs. Flange faces gearwheel of 1st gear

23

Input shaft

1

Porsche Classic Models

Porsche Classic Models

The History of Porsche Cars through its generational changes. A must have ebook for any Porsche fanatic, this ebook is a reference book for Porsche enthusiasts. Discover all there is to know about the greatest Porsches ever made. All models are fully described and illustrated providing a definitive production history plus an accurate guide to original specs and equipment.

Get My Free Ebook


Responses

  • EVELIINA INBERG
    How to make a simple hho dry cell?
    7 years ago
  • Kevin
    Where is the shift fork shaft of gear?
    7 years ago

Post a comment