Installing support for auxiliary stop light

To fit the auxiliary stop light, remove the rear cover, the gas springs and the wiring harness

The auxiliary stop light can be fitted both to the Coupe and to the Cabriolet. No. Operation Instructions

1 Disconnect electrical connectors

Remove cover

Replace gas springs

Drill mounting holes for support and wiring harness passage (outside)

Drill mounting holes for support and wiring harness passage (inside)

Replace wiring harness

Route wiring harness section to auxiliary stop light inside

Route wiring harness section to auxiliary stop light across

Uncllp cap from wiring harness connector, disconnect connector and pull wiring holder from hinge. Screw out ground strap mounting nut.

Screw out mounting bolts and lift cover off the vehicle. Place cover on a soft, clean support.

Remove retaining clips and pins. Remove left and right gas springs, fit shorter gas springs and refit them with

Mark outside hole positions on left and right side of cover, centerpunch, drill, deburr and touch-up bare metal

Mark inside hole positions on left and right side of cover, drill, deburr and touch up bare metal spots with

Unclip engine compartment lamp from cover and disconnect connector. Unclip limit switch connector and disconnect limit switch and drive motor connector. Unclip wire bracket. Refit wiring harness with auxiliary stop light con-

Route wiring harness through hole on inside of cover. Place grommet into position and route harness towards outside across hole in cover.

Route wiring harness across spacer and lamp support. Clip fasteners into auxiliary stop light and reconnect wi-

No. Operation

9 Install auxiliary stop light

10 Install lamp holder

Instructions

Place auxiliary stop light into lamp holder and fit into place with 3.5 x 20 oval-head sheetmetal screws.

Fit spacers onto mounting studs of lamp holder. Engage mounting studs of lamp holder across mounting holes in outer cover panel and tighten from inside with VM6 mounting flange nuts. Refit cover and reconnect wiring.

66 40 23 Installing support for auxiliary stop light

Printed in Germany - VI, 1994

66 38 13 Fastening roof cover Bonding locking bolts to rear window

The following tools, materials and spare parts are required for bonding the locking bolts to the rear window.

Porsche Classic Models

Porsche Classic Models

The History of Porsche Cars through its generational changes. A must have ebook for any Porsche fanatic, this ebook is a reference book for Porsche enthusiasts. Discover all there is to know about the greatest Porsches ever made. All models are fully described and illustrated providing a definitive production history plus an accurate guide to original specs and equipment.

Get My Free Ebook


Post a comment