Note

When carrying out measurements, the drive pinion must be blocked with Special Tool 9339.

1129-39

9. After turning the ring gear a further 90* each, repeat measuring procedures three times. The measured values must not deviate from one another by more than

Note

The backlash to be adjusted is embossed on the ring gear. The actual value may be less than the specified value by - 0.05 mm. Under no circumstances must the backlash be greater than the specified value.

10. If the required backlash cannot be obtained, replace spacers (S1 + S2) again. The total shim thickness (S tot.) must not

Note

Changing the shim thickness of "S1" or "S2" by 0.05 mm shim results in a change of backlash by approx. 0.1 mm.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment