Notes on assembly

1. Press in ball sleeves, shaft seal and trans mission bearing to correct position.

1642-34

1 - Short ball sleeve (press in flush)

2 - Long ball sleeve

3 - Shaft seal

A - Assembly mark (must point upwards)

2. Reassemble reverse idler gear with thrust washers and bolt in correct position (refer to exploded view). With thrust washers and bolt located correctly, the end clearance of the reverse idler gear is 0.15...0.35 mm.

520-34

A = Feeler gauge

3. Check end clearance of reverse idler gear with feeler gauge.

34 52 37 Dismantling and assembling gear housing

Tools

Porsche Classic Models

Porsche Classic Models

The History of Porsche Cars through its generational changes. A must have ebook for any Porsche fanatic, this ebook is a reference book for Porsche enthusiasts. Discover all there is to know about the greatest Porsches ever made. All models are fully described and illustrated providing a definitive production history plus an accurate guide to original specs and equipment.

Get My Free Ebook


Post a comment