Partly renewing rear section of body

Renewing cross-member with engine mount, partly renewing side panels, rear wheel housings and side members

Partly renewing rear section of body

Operation

Instructions

Place car on body alignment rig

Separate the side panel welds in the damaged area

Separate the side panels

Cut away the rear wheel housings and the side

Cut away the side members in a stepped pattern

Separate the brazed joint for

Mount the car with mechanical assemblies in position at the front on the basic set of aligning angles and secure

In the damaged body area, separate the spot welds between the side panels and the rear wheel housings

Grind away the MIG weld seams between the side panels and the cross-member.

Cut away the damaged side panel areas with the body

Cut away the damaged areas of the rear wheel housings and the side members with the body panel saw.

Cut away both side members so that the cut edges of the side members form a step in relation with the cut edges ot the rear wheel housings.

Separate the spot weld joints between the side members and the rear wheel housings using spot weld cutters. Cut away the side members with the body panel saw after they have been separated.

Separate the brazed joint for the lid release cable guide tube on the rear wheel housing and at the lock post.

Porsche Classic Models

Porsche Classic Models

The History of Porsche Cars through its generational changes. A must have ebook for any Porsche fanatic, this ebook is a reference book for Porsche enthusiasts. Discover all there is to know about the greatest Porsches ever made. All models are fully described and illustrated providing a definitive production history plus an accurate guide to original specs and equipment.

Get My Free Ebook


Post a comment