Remov and installing the wiring harness for the transmission

Removing

1. Remove the transmission underbody cladding.

6. Mark the push-on sleeves for re-installation and pull off from the solenoid valves.

3S7-3Ba

4. Unscrew the hexagon nut for the transmission socket with a suitable extension.

5. Remove hydraulic control unit with wire harness (see also page 38-113).

2. Remove multi-functional switch (see page 37-105).

3. Disconnect the connector from the transmission socket. To do this, turn the bayonet lock to the left and disconnect the connector:

Installing

1. Push the push-on sleeves for the solenoid valves up to the stop. Pay attention to cable colors.

383-38

38 18 19 Remov. and installing the wiring harness for the transmission 38-111

Printed in Germany - V, 1994

Solenoid valves

Solenoid valve 1 Solenoid valve 2 Solenoid valve 3 Pressure regulator

Cable colors

(grey-violet) (green-violet) (red-violet) (blue-violet)

2. Route wiring harness and hang in cable

6. Connect wiring harness with transmission socket. To do this, carefully insert the connector in the socket (fits only in one position) and lock by turning the bayonet lock to

367-36b

7. Install the multi-functional switch and

3. Place hydraulic control unit on a suitable surface (e.g. transmission jack) at installation height.

4. Insert the socket with new O-ring so that the flattened side faces upwards. Tighten hexagon nut with 12 Nm (9 ftlb).

5. Install hydraulic control unit.

38 18 19 Remov. and installing the wiring harness for the transmission

Printed in Germany - V, 1994

Porsche Classic Models

Porsche Classic Models

The History of Porsche Cars through its generational changes. A must have ebook for any Porsche fanatic, this ebook is a reference book for Porsche enthusiasts. Discover all there is to know about the greatest Porsches ever made. All models are fully described and illustrated providing a definitive production history plus an accurate guide to original specs and equipment.

Get My Free Ebook


Post a comment