Elimination

Switch off ignition

Pull plug off the control module

Pull plug off the servomotor for HBA

Check for open circuit in the supply leads to the servomotor for

Ohmmeter display < 5 Ohm

Check for short to B+ in the supply leads to the servomotor for HBA Ohmmeter connected to terminals 1, 2, 3, and 4; measure resistance

Ohmmeter display °° Ohm

Check for short circuits between the supply leads.

If no fault is detected in the wires, replace the servomotor for HBA. Also check the plug on the wiring harness side and replace if necessary.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment