Info

Voltmeter at alarm system control module plug I pin 5 and ground Ohmmeter at alarm system control module plug I pin 5 and ground Ohmmeter at alarm system control module plug I pin 5 and plug on

Ohrrimeter at alarm system control module plug I pin 28 and plug on

If no faults are detected in the wire, replace the door lock on the

Test point 44

Drive motor, central locking system

Fault code 45

1. Pull plug II off the alarm system control module,

2. Disconnect plug connection X 11 (driver's side).

3. Disconnect plug connection X 12 (passenger's side).

4. Switch ignition on.

5. Connect voltmeter to plug II pin 9 and ground,

Display:

0 volts

6. Connect voltmeter to plug II pin 3 and ground.

7. Switch off ignition.

8. Ohmmeter at plug X 11 pin S 11 and pin S24 (sleeve side).

9. Ohmmeter at plug X 11 pin S 11 and pin SI7 (sleeve side). Ohmmeter at plug connection X 12 pin 11 and pin 24 (sleeve side).

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment