Test point

Trigger counter This fault is stored in the memory when the roll-over bar has been

Fault code 13 triggered more than 200 times. The fault can initially be erased using the Porsche System Tester 2, but reappears as soon as the ignition is switched off and on again.

Replace roll-over bars. Replace control module.

Test point 12

Fault code 20, 21,

This fault is stored in the memory if a defect is detected in level Replace control unit.

Test point 13

Fault code 24, 25,

This fault is stored in the memory if a defect is detected in level Replace control unit.

Test point 14

Acceleration sensor Fault code 28

This fault is stored in the memory if a defect is detected in Replace control module.

Test point 15

Solenoid valve 1, actuation Fault code 100

This fault is stored in the memory in the event of a short circuit in the supply lead of solenoid valve 1 during triggering.

1. Check supply lead of solenoid valve for short circuit.

2. After eliminating the fault, replace control module. Note

This fault cannot be erased with the Porsche System Tester 2

Test point 16

Solenoid valve 2, actuation Fault code 101

This fault is stored in the memory in the event of a short circuit in the supply lead of solenoid valve 2 during triggering.

1. Check supply lead of solenoid valve for short circuit.

2. After eliminating the fault, replace control module. Note

This fault cannot be erased with the Porsche System Tester 2.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment