Adjusting Transmission Suspension

To prevent stress in transmission suspension and to provide good insulation, transmission mounts have to be adjusted.

Note

There must be at least 1 mm clearance between transmission case and side stop on transmission mount after tightening the mounting bolts.

1, Install transmission and rear axle. Tighten transmission mount to transmission case bolts to specified torque.

2. Screw in cross member to transmission mount bolts several turns.

3. Lift transmission at center of case enough so that there is a gap between both transmission mounts and the cross member. Measure this gap on both sides and take up difference with shims.

4. Place shims of determined thickness between the transmission mount and cross member, lower transmission and tighten transmission mount to cross member bolts to specified torque.

No.

Description

Qty.

Note When: Removing Installing

Special Instructions

Was this article helpful?

0 0

Post a comment