Info

If replaced, readjust connection between flywheel and drive plate (page 39 - 51)

Note

Two drive plates (each 1.5 mm thick) have replaced the single drive plate (2.0 mm thick).

In conjunction with this change the input flange (Pos. 2) also had to be modified.

Since spare parts of former version are no longer available, when repairing cars with only one drive plate they must be changed to the new version.

2. Press grooved ball bearing off of drive flange with Special Tool VW 457,

To prevent the drive flange from moving out while pressing in the bearing, it must be supported from underneath with a suitable thrust pad.

Was this article helpful?

0 0

Post a comment